Operation; Playback; Set The Power To Standby - Pioneer Elite A-20 Operating Instructions Manual

Operation

Chapter 4:
Operation

Playback

SACD/CD player
Network audio player
NETWORK AUDIO PLAYER N-50
/I STANDBY/ON FUNCTION  
STANDBY PURE AUDIO Hi-Bit 32
 
iPod/USB
5V 2.1A
2 6
Playback
6 6
1 Turn on the power of the playback
component.
2 Turn power ON to the unit.
• If the unit is in the standby mode, press the remote
control's  STANDBY/ON button.
3 Select the source you want to playback.
Select the playback component.
• When using the front panel controls, rotate the
INPUT SELECTOR knob.
iPod dock, etc
Turntable
CD recorder or
iPod
Music>
Extras>
tape deck
Settings>
Shuffle Songs
Backlight
Tuner
MENU
 

Playback
5 3
4 Start playback of the component you
selected in step 1.
5 Adjust playback volume with VOLUME
control.
6 Adjust the tone to your preference using
the BASS and TREBLE controls, and
LOUDNESS button.
If the DIRECT button has been set to ON, these controls
are disabled.

Set the power to Standby

Press the remote control's  STANDBY/
1
ON button.
The next time you wish to turn on the power, press the
remote control's  STANDBY/ON button.
• If the front panel's  STANDBY/ON button is
pressed, the power will be turned off. In this case, if
the power is off, pressing the remote control's 
STANDBY/ON button will not turn on the power. To
turn on the power again, press the front panel's 
STANDBY/ON button.
Note
• If the power cord is disconnected when the unit is
in the standby mode the unit will turn off, but when
the cord is then reconnected, the unit will not
automatically turn on. After reconnecting the
power cord, press the remote control's
 STANDBY/ON button to turn the power on.
04
11
En