Desa Comfort Glow RFP30T Owner's Operation And Installation Manual page 11

OWNER'S MANUAL
INSTALLATION
Continued
Securing Hearth Base to Floor
I. Position hearth base in desired location.
Mark holes for drilling (See Figure 18).
Remove hearth base.
2,
For carpeted floor, make a small cut
with a sharp knife at marked loca-
tions before drilling. If securing to a
wood floor, drill a 3/4" deep hole
using a 1/8" diameter drill bit. Do not
use anchors in wood floors.
If securing to a concrete floor, drill a 1
3/8" deep hole using a 1/4" diameter
concrete drill bit. Completely insert
anchors into each hole.
3.
Mount heater to hearth base following
steps under Mounting Heater to Op-
tional Hearth Base, below. After
mounting heater, position heater and
hearth base over drilled holes. With
slotted screwdriver, secure hearth base
to floor with four wood screws.
Mounting Heater to Optional
Hearth Base
1. Lay heater on its back on a table with
the bottom of heater overhanging the
edge of the table.
2. Remove 2 shipping screws in bottom
of heater. Discard shipping screws.
3. Line up mounting holes on top of hearth
base with holes in bottom of heater (see
Figure 18).
4. Using a Phillips screwdriver, secure
hearth base to heater with four sheet
metal screws (see Figure 18).
5. Stand heater up on base.
6. Place hearth insert in hearth base as
shown in Figure 19,
7. Assemble brass trim (see steps 1
through 7 under Assembling and At-
taching Brass Trim, page 5).
8. Slide base trim on heater base. Attach
brass trim to base with two brass screws
included as shown in Figure 19 below.
Bottom of Heater
Shipping
Screw
Base
Holes
Holesfor Securing
Heater to Floor
Sheet Metal Screw
Figure 18 - Attaching Heater to Hearth
Base
Laminate
Sheet
Insert
Screw
Brass Base
Trim
Figure 19- Placing HearthInserton Heater
Base and Attaching Brass Base Trim
C. MOUNTING HEATER WITH
OPTIONAL HEARTH BASE (IF
APPLICABLE) TO OPTIONAL
MANTEL
See Instructions Included With
Mantel Kit.
Assembling Mantel
IMPORTANT:Only use the optional man-
tels specified in this manual. See Accesso-
ries, page 21 for proper mantel kits. This
heater is only approved for use with models
GMFB00/GMUB01 series, GM900F/
GM901U series, GMT00F/GM701U series,
GMC22F/GMC23U/GMC24U series,
GMC32F/GMC33U series, GMC34F/
GMC35U series and GMC26F/GMC27U/
GMC28F series mantel kits. Using any
other mantel will void the A.G.A. approval
for this heater. Do not use models GMF800/
GMUB01 series, GM900F/GM901U series,
GM700F/GM701U series, GMC22F/
GMC23U/GMC24U series, GMC32F/
GMC33U series, GMC34F/GMC35U se-
ries and GMC26F/GMC27U/GMC28F
mantels with any other product. If the metal
base is required with your mantel, the heater
must be mounted on the base first
Continued
lcw._ 11