Related Manuals for Lewmar Gen 2 S2000
Summarization of Contents
Introduction
Product Support
Information regarding support network and contact details for Lewmar products.
CE Approvals
Mentions CE approval certificates and important safety information within the manual.
Specification
Electric Specifications
Table detailing motor supply, power, current draw, circuit breaker, and weight for models.
Gypsy Specifications
Specifies gypsy suitability for leaded lines of 12 to 16mm diameter.
Safety Notice
Windlass General Safety
General safety warnings and important considerations for operating and maintaining the windlass.
Fitting Safety
Emphasizes adherence to manual instructions for safe and correct installation of the windlass.
Electrical Safety
Highlights electrical safety requirements, including power isolation and qualified installation.
Installation
Basic Requirements
Lists essential tools required for both the windlass and electrical wiring installation.
Accessories
Advises using genuine Lewmar parts to ensure optimal performance and maintain warranty coverage.
Bulkhead Preparation
Provides crucial guidance on planning and preparing the vessel's bulkhead for windlass mounting.
Electrical Wiring
Electric Cable Selection
Guidelines for selecting appropriate electrical cable sizes based on model, length, and current draw.
Wiring Guidelines
Planning advice for wiring systems, including wire types, insulation, and overload protection.
Control Switch Installation
Information on installing control switches, contactors, and optional remote controls.
Operation
Manual Controlled Freefall
Procedure for deploying the anchor using manual freefall, including safety warnings.
Power Up/Down Operation
Instructions for operating the windlass for anchor release and retrieval via power.
Servicing
Servicing Schedule
Outlines recommended servicing intervals and checks for maintaining the windlass.
Gypsy Replacement and Service
Step-by-step guide for removing, servicing, and replacing the windlass gypsy.
Troubleshooting
Anchor Rode Pays Out Independently
Addresses issues where the anchor rode deploys unintentionally when the windlass is not in use.
Failure to Operate or Sluggish Operation
Guides on diagnosing and resolving common problems like the windlass not working or operating slowly.
Need help?
Do you have a question about the Gen 2 S2000 and is the answer not in the manual?
Questions and answers