Cleaning And Maintenance - Desa CDR3924NT Owner's Operation And Installation Manual

Unvented (vent-free) gas log heater
Table of Contents

Advertisement

CLEANING AND
MAINTENANCE
WARNING: Turn off heater
and let cool before cleaning.
CAUTION: You must keep con-
trol areas, burners, and circulating
air passageways of heater clean.
Inspect these areas of heater
before each use. Have heater
inspected yearly by a qualified
service person. Heater may need
more frequent cleaning due to
excessive lint from carpeting, pet
hair, bedding material, etc.
WARNING: Failure to keep
the primary air opening(s) of
the burner(s) clean may result in
sooting and property damage.
BURNER INJECTOR HOLDERS AND
PILOT AIR INLET HOLES
The primary air inlet holes allow the proper amount
of air to mix with the gas. This provides a clean
burning flame. Keep these holes clear of dust, dirt,
lint, and pet hair. Clean these air inlet holes prior to
each heating season. Blocked air holes will create
soot. We recommend that you clean the unit every
three months during operation and have heater
inspected yearly by a qualified service person.
We also recommend that you keep the burner
tubes and pilot assembly clean and free of dust
and dirt. To clean these parts we recommend using
compressed air no greater than 30 PSI. Your local
computer store, hardware store, or home center
may carry compressed air in a can. You can use a
vacuum cleaner in the blow position. If using com-
pressed air in a can, please follow the directions on
the can. If you don't follow directions on the can,
you could damage the pilot assembly.
1. Shut off the unit, including the pilot. Allow
the unit to cool for at least thirty minutes.
2. Inspect burners, pilot, and primary air inlet
holes on injector holder for dust and dirt (see
Figures 28 or 29).
3. Blow air through the ports/slots and holes in
the burners.
4. Check the injector holders located at the end
of the burner tubes again. Remove any large
113183-01B
Figure 28 - Injector Holder On Outlet
Figure 29 - Injector Holder On Front
Figure 30 - Cleaning Pilot Air Inlet Hole
(Your pilot may vary from pilots shown)
www.desatech.com
Burner Tube - Rear Burner
Outlet Burner Tube
Access
Hole for
Cleaning
Natural
Pilot
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdr3924pt

Table of Contents