Measurement Examples; Example Parameter Settings For Several Protocol Types; E1_Euro_Isdn - OPTICOM OPERA E1-T1 User Manual

Interface option
Table of Contents

Advertisement

C H A P T E R
6 :
M E A S U R E M E N T

6 Measurement Examples

This chapter will be helpful if you are not yet familiar with the OPERA™
E1/T1 option. The first section provides some example parameter settings for
all protocol types available. Section 6.2 demonstrates a typical loop
measurement using OptiCall™, while 6.3 will show a typical application of
an automated measurement using a script file. Both examples put the
emphasis on the signal acquisition. If you are looking for examples of how
to use the OPERA™ analyzer, please refer to the OPERA™ user manual.
6.1

Example Parameter Settings for Several Protocol Types

In the following, a number of tables containing parameter configurations are
listed. These tables represent example settings for all protocol types
available, except for the transparent protocol types. The parameter
configuration is divided into two sets, the trunk parameters and the B-
channel parameters. In the case of those protocol types that do not support
any B-channel parameters, you may simply omit the configuration of those
parameters. Some of the supported protocols are not symmetrical, that is,
that the user and the network side of the protocol are different. The relevant
configuration field is "Termination Side". Please note, that currently only
identical configurations for all trunks of a board are supported. As a
consequence, it is currently not possible to configure one trunk as the user
side and the other as the network side of the protocol.

6.1.1 E1_Euro_ISDN

E1_Euro_ISDN
is
corresponding termination side for the user or the network.
Field Name
Protocol Type
Protocol Version
Protocol Subversion
Call Progress Tone Configuration
Dchannel Configuration
Line Code
T1 Framing Method
CAS ABCD Idle Pattern
Coding Law
Termination Side
Overwrite Register Values
Table 6.1: Trunk parameter settings for E1_Euro_ISDN.
Field Name
Destination Numbering Type
Destination Numbering Plan
Source Numbering Type
Source Number Presentation
Source Number Screening
Source Phone Number
Source Phone Subnumber
Transfer Capability
Inter Exchange Prefix Number
E X A M P L E S
a
non-symmetrical
21
protocol.
Please
select
Value
E1_Euro_ISDN
-
-
CPIsrael
Primary
HDB3
-
-
Alaw
User, respectively Network
Off
Value
Unknown Number
ISDN Numbering Plan
Unknown Number
Presentation Allowed
User Provided
-
-
Voice Service
-
the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Opr-002-e1t-p

Table of Contents