Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for PRODIS C80
Summarization of Contents
1. INTRODUCTION
1.1. Warnings and Safety Precautions
Details crucial safety guidelines, intended use, and warnings for operation and maintenance.
2. INSTALLATION
2.1. Placement of the Ice Maker
Guidelines on selecting a suitable location, considering operational temperature, air flow, and heat sources.
2.2. Levelling the Ice Maker
Instructions on how to ensure the ice maker is perfectly leveled using adjustment legs and a level.
2.4. Minimum Clearance Requirements
Specifies the essential minimum distances to obstacles for proper operation and efficient service.
2.6. Drain Connection
2.6.1. Gravity Drain Setup
Instructions for setting up a gravity drain, including hose diameter and gradient requirements.
2.6.2. Drain Force Connection
Describes the drain force system allowing horizontal and vertical drain installations.
3. PRIOR CHECKING AND START-UP
3.1. Pre-Operation Checks
Checklist of essential steps before starting the machine, including leveling, voltage, and connections.
3.2. Machine Start-Up Procedure
Step-by-step guide for initiating the ice maker's operation after installation and prior checks.
4.1. Control Board Overview
PCB Connections and Outputs
Details the electrical connections for outputs like compressor, pump, and valves on the control board.
LED Status Indicators
Explanation of the orange and red LEDs that signal machine status and alarms.
4.2. Alarms and Error Detection
Safety High Pressure Switch Alarm
Details the alarm triggered by the high-pressure switch and its reset mechanisms.
Long Harvest Alarm
Describes the alarm for an excessively long harvest cycle and its consequences.
Ice Production Cycle Timeout Alarm
Explains the alarm when the production cycle exceeds the allowed time limit.
Faulty Temperature Probe Alarm
Information on the alarm indicating a broken or disconnected evaporator temperature probe.
4.4. Drain Force System
4.4.1. Drain Force Sequence
Explains the operation of the drain force system, including water evacuation and pump activation.
4.4.2. Drain Force Control Board
Drain Force LED Indicators
Details the LEDs that indicate the status of the water pump and water level sensor for the drain force system.
6. Maintenance and Cleaning Procedures
6.1. Cleaning the Water Distribution System
Steps for cleaning the water distribution system, including removing ice and using cleaning solutions.
7. User Troubleshooting Guide
7.1. General Troubleshooting Questions
Addresses common problems like no power, no ice, or incorrect cube formation with possible causes and solutions.
7.2. Drain Force Troubleshooting
Troubleshooting specific issues related to the drain force system, such as flooded bins or pump operation.
Need help?
Do you have a question about the C80 and is the answer not in the manual?
Questions and answers