Table of Contents
Advertisement
INSTALLING
Continued
103296
INSTALLING LOG HEATER IN FIREBOX
Do not pick up log base assembly by burners. This could damage
burners. Only handle base by grates.
1. Remove four screws holding firebox bottom in place.
2. Lift and remove firebox bottom (see Figure 10).
3. If installing GA3500A Blower Accessory (Model FB32C only), see Installing
Blower Accessory, page 12.
Figure 10 - Removing Firebox Bottom
4. Route flexible gas line from manual shutoff valve into firebox through side.
Most building codes do not permit concealed gas connections. A
flexible gas line is provided to allow accessibility from the firebox.
The flexible gas supply line connection to the manual shutoff
valve should be accessible.
5. Attach gas log heater base to firebox bottom with four screws included with
base (see Installing Heater Base Assembly in log set owner's manual).
6. Replace firebox bottom and secure with screws.
IMPORTANT:
If installing a VL18N/P, VL18NT(A)/PT(A), VL24N/P,
VL24NT(A)/PT(A), VS24NV(A)/PV(A), VS18NV/PV, VS24NTA/PTA,
VS18NTA/PTA, CF18N/P, CF18NT(A)/PT(A), CF24N/P, CF24NT(A)/PT(A),
CFS24NV(A)/PV(A), CF18NV/PV, CF24NTA/PTA, or CF18NTA/PTA gas log
heater, locate two mounting brackets included with appliance. Measure these
brackets. If overall length is 9 1/4", cut 2" off rear of each bracket with hacksaw
(see Figure 11).
Screws
CAUTION
WARNING ICON
G 001
NOTICE
Figure 11 - Cutting Brackets
Heater Base
Mounting
Bracket
Firebox Bottom
13
Advertisement
Table of Contents
