Biostar TP45E XE Setup Manual page 25

Notices:
Not all types of Intel CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under "Overclocking Navigator Engine" item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is "Disabled"; the condition parameter should
be changed to "Enable" to proceed this test.
Main Advanced
Over-Clocking Navigator setting
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Over-Clocking Navigator
=========== Automate OverClock System ===========
Auto OverClock System
============ Manual OverClock System ============
Intel(R) SpeedStep(tm) tech
Ratio CMOS Setting
CPU Frequency Setting
Over Clock Retry Count
FSB(Bsel) To NorthBridge Latch [Auto]
DRAM Frequency
Enhanced Mode
> DRAM Timing Configuration
> Clock Gen Configuration
> Voltage Configuration
Memory Test
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Main Advanced
Over-Clocking Navigator setting
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Over-Clocking Navigator
=========== Automate OverClock System ===========
Auto OverClock System
============ Manual OverClock System ============
Intel(R) SpeedStep(tm) tech
Ratio CMOS Setting
CPU Frequency Setting
Over Clock Retry Count
FSB(Bsel) To NorthBridge Latch [Auto]
DRAM Frequency
Enhanced Mode
> DRAM Timing Configuration
> Clock Gen Configuration
> Voltage Configuration
Memory Test
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from "Enable" to "Disable"
to complete the test.
BIOS SETUP UTILITY
PCIPnP Boot
Chipset
[Normal]
[V6-Tech Engine]
[Enabled]
[ x8.0]
[200]
[3]
[Auto]
[Auto]
[Disabled]
↓
BIOS SETUP UTILITY
PCIPnP Boot
Chipset
[Normal]
[V6-Tech Engine]
[Enabled]
[ x8.0]
[200]
[3]
[Auto]
[Auto]
[Enabled]
TP45E XE
O.N.E Exit
Options
Disabled
Enabled
Select Screen
Select Item
Go to Sub Screen
Enter
F1 General Help
F10 Save and Exit
ESC Exit
O.N.E Exit
Options
Disabled
Enabled
Select Screen
Select Item
Go to Sub Screen
Enter
F1 General Help
F10 Save and Exit
ESC Exit
23