Removal Of The Sending Unit - VDO SUMLOG Manual

Install flooding valve
and sending unit:
3. Put the loop of the control rope around the hull sleeve and knot the
loose end of the rope to the blind plug.
4. Screw the flood valve to the hull sleeve until an audible click indi-
cates secure seating, is heard.
5. Insert the sending unit from the top and secure it with the nut.
Bow
Note the correct direction when inserting the sending
unit. The pointed side of the sending unit loop must be
directed towards the bow as soon as the sending unit
has been inserted.

Removal of the sending unit

Loosen the union nut and pull the sending unit from the sleeve by rota-
ting it slightly. Immediately insert the blind plug.
Never pull on the cable to remove the sending unit. Always
use the loop. Always insert the blind plug when the sending
unit has been removed.
INSTALLATION
5
4
3
35