Table of Contents
Advertisement
BASIC OPERATIONS (CONT)
15. Loop EDITIng
The UCD-200 allows you to edit loops on the fly by pressing the IN and OUT BUTTONS. By pressing
the IN BUTTON at your desired point you can move your loop "in" point forward. The OUT BUTTON
will exit the loop
you can also edit the loop by pressing the RELOOP BUTTON. Press this button for about 2 seconds,
the LCD screen will display "edit" and display the time of your "out" point. you can now use the JOG
wHEEL to fine tune your loop and "out" point. Turning the JOG wHEEL clockwise will move your
"out" point forward, lengthening your loop. Turning the JOG wHEEL counter-clockwise will move
your "out" point backwards, shorting your loop.
"FLIP-FLOP' (RELAY) CONNECTION AND SET UP
12. RELAY (FLIP-FLOP™)
This feature is a kind of "auto pilot. " "Flip-Flop™" mode can only function with the both drives of the
UCD-200. with "Flip-Flop™" you can have one disc drive begin playback when the other ends. you
can "Flip Flop™" single tracks, or entire discs.
1) Load disc drives with audio discs or connect USB.
2) Press the RELAy BUTTON (12), the LED above the RELAy BUTTON will light up letting you
know that Flip-Flop™ mode has been activated. Press the SGL/CTN BUTTON (6) to choose
between SINGLE mode or CONTINUOUS mode.
3) After they have both cued, press the PLAy/PAUSE BUTTON (16) on one of your drives to begin
playback.
4) If you have the cd player set to SINGLE mode, the first cds' single track will play and after it has
ended the second cds' track will immediately begin playback. If the player is set to CONTIN-
UOUS mode, the first cd will play all the way through, and then after it has ended the second cd
will start.
5) FLIP FLOP™ will continue until you stop it or power is interrupted.
6) To deactivate Flip-Flop™ mode, press the RELAy BUTTON again.
American Audio
- www.americanaudio.us - UCD-200™ Instruction Manual Page 21
©
®
Advertisement
Table of Contents
