Flip-Flop - American Audio RADIUS 3000 User Manual And Reference Manual

fLIp-fLOp™

fLIp-fLOp™
This feature is a kind of "auto pilot". When you are using two Radius 3000™ players and an American Audio®
"Q" Deck™ mixer, you can have one player begin playback when the other ends. You can "Flip-Flop™" single
tracks, the entire media source, or a combination of the two.
To FLIP-FLOP™ single tracks:
1) Connect your system as described in the connection section on page 8.
2) Set your American Audio® "Q" Deck™ mixer's crossfader to the center
position.
3) Set your two Radius 3000s™ to playback in single mode, Single (57)
should be indicated in the Vfd (3).
4) Load your two Radius 3000s™ with audio discs.
5) After they have both cued, press the play/pauSe Button (13) on one
player to begin playback.
6) After the first player's single track has ended the second player's track will
immediately begin playback.
7) FLIP-FLOP™ will continue until you stop it or power is interrupted.
Note:
You may combine FLIP-FLOP™ single and continuous playback modes by selecting either single or
continuous playback on your units.
Connecting your Radius 3000™ to an American Audio® or an American DJ® "Q" Deck™ mixer for "Flip-
Flop™" control: Be sure to connect 1/8" mono mini plugs from the control connection on the rear of your
Radius 3000™ to the 1/8" control jack on the rear of American Audio® "Q" series mixer. That's it, you'll be set
for FLIP-FLOP.™
Sample "Q" Start Set-Up. This set-up will allow "Q" start function and Flip-Flop™ function to operate.
Be sure to use 1/8" mono mini plugs only.
©
American Audio - www.AmericanAudio.us - Radius 3000™ Instruction Manual Page 41
®
Compatible Q-Deck mixer
Single black cross line
Single black cross line
mono mini plug
Figure 55