Table of Contents
Advertisement
BASIC OPERATIONS (CONT)
15. LOOP EDITING
The UCD-200 allows you to edit loops on the fly by pressing the IN and OUT BUTTONS. By pressing
the IN BUTTON at your desired point you can move your loop "in" point forward. Pressing the OUT
BUTTON will exit the loop.
you can also edit the loop by pressing the RELOOP BUTTON. Press this button for about 2 seconds,
the LCD screen will display the time of your "out" point. you can now use the JOG wHEEL to fine
tune your loop and "out" point. Turning the JOG wHEEL clockwise will move your "out" point for-
ward, lengthening your loop. Turning the JOG wHEEL counter-clockwise will move your "out" point
backwards, shorting your loop.
"FLIP-FLOP' (RELAY) CONNECTION AND SET UP
16. RELAY (FLIP-FLOP™)
This feature is a kind of "auto pilot. " "Flip-Flop™" mode can only function with the both drives of the
UCD-200. with "Flip-Flop™" you can have one drive begin playback when the other ends. you can
"Flip Flop™" single tracks, or entire music source device.
1) Load disc drives with audio discs or connect USB.
2) Press the RELAy BUTTON (12), the LED above the RELAy BUTTON will light up letting you
know that Flip-Flop™ mode has been activated. Press the SGL/CTN BUTTON (6) to choose
between SINGLE mode or CONTINUOUS mode.
3) After they have both cued, press the PLAy/PAUSE BUTTON (16) on one of your drives to begin
playback.
4) If you have the player set to SINGLE mode, the first single track will play and after it has ended
the second track will immediately begin playback. If the player is set to CONTINUOUS mode, the
first music source will play all the way through, and then after it has ended the second music
source will start.
5) FLIP FLOP™ will continue until you stop it or power is interrupted.
6) To deactivate Flip-Flop™ mode, press the RELAy BUTTON again.
American Audio
- www.americanaudio.us - UCD-200 Instruction Manual Page 21
©
®
Advertisement
Table of Contents
