ACRONIS Backup & Recovery 10 Server for Windows User Manual page 75

5. Click Additional e-mail parameters, to configure additional e-mail parameters as follows, then
click OK:
From - type the e-mail address of the user from whom the message will be sent. If you leave
o
this field empty, messages will be constructed as if they are from the destination address.
Use encryption – you can opt for encrypted connection to the mail server. SSL and TLS
o
encryption types are available for selection.
Some Internet service providers require authentication on the incoming mail server before
o
being allowed to send something. If this is your case, select the Log on to incoming mail
server check box to enable a POP server and to set up its settings:
•
Incoming mail server (POP) – enter the name of the POP server.
•
Port – set the port of the POP server. By default, the port is set to 110.
•
User name – enter the user name
•
Password – enter the password.
Select the Use the specified outgoing mail server check box to enable an SMTP server and to
o
set up its settings:
•
Outgoing mail server (SMTP) – enter the name of the SMTP server.
•
Port – set the port of the SMTP server. By default, the port is set to 25.
•
User name – enter the user name.
•
Password – enter the password.
Click Send test e-mail message to check if the settings are correct.
Messenger service (WinPopup)
This option is effective for Windows and Linux operating systems.
This option is not available when operating under bootable media.
The option enables you to receive WinPopup notifications about about the recovery task's successful
completion, failure or need for interaction.
The preset is: Disabled.
Before configuring WinPopup notifications, make sure the Messenger service is started on both the
machine executing the task and the machine that will receive messages.
The Messenger service is not started by default in the Microsoft Windows Server 2003 family. Change
the service Startup mode to Automatic and start the service.
To configure WinPopup notifications:
1. Select the Send WinPopup notifications check box.
2. In the Machine name field, enter the name of the machine to which notifications will be sent.
Multiple names are not supported.
3. Under Send notifications, select the appropriate check boxes as follows:
When recovery completes successfully – to send notification when the recovery task has
o
completed successfully
When recovery fails – to send notification when the recovery task has failed.
o
Copyright © Acronis, Inc., 2000-2009 75