Cascaded Ficon And 2-Byte Addressing Considerations; Configuring Switched Point-To-Point Ficon - Brocade Communications Systems 1606 Administrator's Manual

2

Configuring switched point-to-point FICON

5. Add feature keys, if applicable.
6. Perform a configUpload to save a baseline of the switch configuration.

Cascaded FICON and 2-byte addressing considerations

The following are considerations when installing a switch in a FICON environment where 2-byte
addressing is used. Two-byte addressing is always used in cascaded environments but may be used
in single switch fabrics as well. Making changes to your switch or director may require scheduled
downtime.
•
•
•
Configuring switched point-to-point FICON
Use the worksheet in
information. These steps assume you have used your hardware reference manual to perform the
initial setup of the switch and have performed all the steps from
page 15.
CAUTION
Configuring the switch for FICON is a disruptive process. The switch must be disabled to configure
switch parameters.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the switchDisable command. You will need to disable the switch to access all the switch
3. Configure the switch and chassis name, if applicable.
4. Take the appropriate action based on whether you have both B- and M-series switches in your
16
All fabric operating parameters, such as time-out values, must be the same. If you have not
made any changes outside the scope of this document there is nothing additional to consider
regarding these parameters.
The domain IDs of all switches must be unique and insistent.
Although not required, it will be easier to configure the security policies if the zoning matches.
Configuration, connecting the ISLs, and ensuring that the switches and directors have merged
into a fabric, will also make the process of setting the security attributes much easier.
Appendix A, "Configuration Information Record,"
parameters.
fabric:
•
If you do not have both series, proceed to
•
If you have both series, verify that the Fabric Mode is set to 2 on the supported platforms.
Refer to the Fabric OS Administrator's Guide to allow the two device types to
communicate.
to record your configuration
"Preparing a switch for FICON"
step 5.
FICON Administrator's Guide
on
53-1001771-01