Turbo Air TOM-48E Series Installation And Operation Manual

Turbo Air TOM-48E Series Installation And Operation Manual

Open display merchandiser

Advertisement

Turbo Air Speeds up the Pace of Innovation
Open Display Merchandiser
Installation and Operation Manual
Please read this manual completely before attempting to install or operate this equipment.
Extra Deep
TOM-36-DX*-**-*
TOM-48-DX*-**-*
TOM-60-DX*-**-*
Full Heights
Mid Heights
TOM-40*-**-*
TOM-40M*-**-*
TOM-50*-**-*
TOM-50M*-**-*
www.turboairinc.com
Vertical Air Curtain
TOM-36E*-**-*
TOM-48E*-**-*
TOM-60E*-**-*

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TOM-48E Series and is the answer not in the manual?

Questions and answers

Summarization of Contents

Introduction and Customer Support
Customer Service Contact Information
Contact Turbo Air customer service at 1-800-381-7770 for any questions or assistance.
Electrical Safety Warning
Ensure a minimum 20 Amps dedicated outlet and 12 AWG wire for proper and safe operation.
Installation Instructions
Damage Inspection Before Installation
Check for shipping damage with the freight company and report concealed damage within 24 hours.
Optimal Merchandiser Location
Position in an area with ambient temperature of 75°F or colder and 55% relative humidity.
Leveling the Merchandiser
Use leveling legs to ensure the unit is stable and drains properly to prevent water buildup.
Recommended Operating Conditions
Environmental and Placement Guidelines
Avoid direct sunlight, HVAC vents, doorways, and maintain 75°F/55% humidity for optimal performance.
Air Circulation and Product Loading
Ensure adequate clearance for air circulation and do not load products beyond the shelf edge.
Operating Instructions
Power and Light Switches
Locate and operate the red power switch and green light switch on the front panel.
Temperature Adjustment
Adjust the temperature control knob under the bottom shelf for desired cooling.
Product Placement Advice
Wait for desired temperature before loading, do not place hot items, and avoid overloading.
Maintenance and Cleaning
Initial Merchandiser Cleaning
Thoroughly clean the unit before first use using mild soap and water, avoiding harsh detergents.
Condenser Coil Maintenance
Clean the condenser coil every 3 months or as needed by removing covers and brushing.
Troubleshooting Common Issues
Merchandiser Not Functioning
Check power supply, breaker status, and power switch operation.
Merchandiser Temperature Issues
Inspect condenser cleanliness and ensure airflow is not blocked by products.
Lighting Problems
Verify the light switch is on and bulbs are correctly seated in holders.
Warranty Claims Process
Submitting Warranty Claims
All claims must be made directly to Turbo Air with specific supporting documentation.
Compressor Warranty Maintenance Requirements
Outlines essential steps like dryer replacement and micron vacuums for compressor warranty validity.

Table of Contents