Advertisement
Table of Contents
Dell™ PowerVault™ 120T
Service Tag/Plate Information Update
This document describes the procedure for removing the service tag from a defective system and
transferring it to your replacement system.
CAUTION: In order to track the future warranty of your Dell purchased system, you must
follow the instructions outlined below. Failure to perform these steps may result in a delay
in future service for your system.
Service Tag/Plate Transfer Procedure
To transfer the Dell service tag/plate to the replacement system:
1.
Unpack the replacement system.
2.
Shut down the defective system and disconnect the power cable.
3.
Locate the service tag/plate on the defective system (see Figure 1).
www.dell.com
support.dell.com
P/N 3C141 Rev. A00
October 2000
03C141 A00
Advertisement
Table of Contents
Related Manuals for Dell PowerVault 120T DLT1
Summary of Contents for Dell PowerVault 120T DLT1
- Page 1 This document describes the procedure for removing the service tag from a defective system and transferring it to your replacement system. CAUTION: In order to track the future warranty of your Dell purchased system, you must follow the instructions outlined below. Failure to perform these steps may result in a delay in future service for your system.
- Page 2 © 2000 Dell Computer Corporation. All rights reserved. Printed in the U.S.A. Trademarks used in this text: Dell , the DELL E COM logo, and PowerVault are trademarks of Dell Computer Corporation. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Need help?
Do you have a question about the PowerVault 120T DLT1 and is the answer not in the manual?
Questions and answers