Displaying Subcluster Information - Dell DX6000 Administration Manual

5.2. Displaying Subcluster Information

When subclusters are configured, the Node List is grouped first by subcluster name and then by IP
address of the nodes. The first row of each subcluster includes a roll up of the status for the nodes
in the subcluster. The following pictures depict 2 subclusters collapsed and then expanded to show
member nodes.
The display of the cluster nodes and their status information is transmitted periodically. Therefore,
there can be a delay of up to two minutes before node transitions are recorded on the admin
console. This also means that the admin console view may differ slightly when two nodes are
compared to each other. If practical, it is best to remain connected to the same node when using the
admin console in order to avoid confusion with this status propagation delay.
Copyright © 2010 Caringo, Inc.
All rights reserved 29
Version 5.0
December 2010