Dell DX6000 Administration Manual page 36

The following table shows all configurations to control the operation of the DX Storage cluster
nodes. If a parameter name displays as a link, click the link to jump to more information about that
parameter.
Option Name
administrators
archiveMode
autoRepOnWrite
autoValidateRead
cache.percentage (or
percentage)
cache.maxCacheable-
Size (or
maxCacheableSize)
cipTTL
Copyright © 2010 Caringo, Inc.
All rights reserved
Default
{'admin':'ourpwdofchoice-
here',
'snmp':'ourpwdofchoice-
here'}
0
0
0
10
1048576
1
31
Description
List of usernames and passwords authorized
for read/write access to SNMP and the
Admin Console.
User admin with default password
ourpwdofchoicehere can perform write
actions in the Admin Console.
User snmp with default password
ourpwdofchoicehere can perform write
actions using SNMP.
The names admin and snmp are reserved
and should not be changed.
Default of 0 leaves node in a normal
operating state. Set to 1 to set the node to
archive mode, where the node will remain
idle in low-power mode without participating
in cluster activity until its capacity is needed.
Set to 1 to force a replicate-on-write for
every stream. Set to 0 to allow the normal
replication mechanism within the health
processor.
Validate stream contents before returning
successful read response.
Percentage of IO buffer memory reserved
for the content cache. The content cache
speeds up access to frequently accessed
content by storing it in geographically
proximate locations.
The amount of IO buffer memory in a node
displays as an announcement message
when the node starts up. Look for the
following in your announcements: MAIN
ANNOUNCE: Memory allocation at
startup
The default is 10. To disable the content
cache, set it to 0.
Largest size, in bytes, of an object that can
be stored in the content cache. The default is
1,048,576 (1MB).
Allows configuration of multicast network
traffic TTL (time to live). Using the default,
the multicast traffic should remain local.
Version 5.0
December 2010