HP 3000 - 37XE System Release Note page 6

HP StorageWorks Storage System Scripting Utility
The latest version of the Storage System Scripting Utility (SSSU) is available on the software downloads
HP website:
http://www.hp.com/support/downloads
Under storage, click Storage Software, and then select HP StorageWorks Command View EVA under
Storage Device Management Software. Select the version of the HP StorageWorks Command View EVA.
NOTE:
The SSSU cannot run from an ESX or a GSX server. You must use a server running an SSSU-supported
guest Virtual Machine operating software, such as Windows® or Linux®.
Avoiding problem situations
The following sections describe problems that may arise and their solutions.
SSSU
Changing comments on a disk enclosure
Use HP Command View EVA to change comments on a disk enclosure. If you try to change a disk
enclosure comment using SSSU, the following error message appears:
Error: Invalid Operation
Changing the name of a disk enclosure
Changing the name of a disk enclosure is not supported with SSSU or HP Command View EVA. If you try
to change a disk enclosure name using SSSU, the following error message appears:
Error: Invalid Operation
Host considerations
This section contains information and important reminders about the host server.
ProLiant BIOS with multiple HBAs
If you have a ProLiant server with one or more HBAs installed, you must change the MPS Table Mode
setting in the BIOS; otherwise, the system may not be able to detect all attached devices.
To change the setting:
1. Press F1 to access the ROM-Based Setup Utility (RBSU) during power-on self-test (POST).
This typically occurs after 5i Disk Array initialization.
2.
Select System Options > OS Selection > Windows.
3. Select Advanced Options > MPS Table Mode.
4.
Select FULL TABLE APIC.
5.
Press Esc twice, and then press F10 to save the configuration.
6