Advertisement
session target
To configure an ATM network-specific address for a permanent virtual connection (PVC) or switch
virtual connection (SVC) dial peer, enter the ATM form of the session target dial-peer configuration
command. The no form of the command disables the feature.
session target atm interface {svc nsap nsap-address | pvc {name | vpi/vci | vci}
no session target
Syntax Description
interface
nsap-address
name
vpi/vci
vci
Default
Enabled with no IP address or domain name defined.
Command Mode
Dial-peer configuration
Command History
Release
11.3(1) T
11.3(1) MA
12.0(3)XG and 12.0(4)T
12.0(5)XK and 12.0(7)T
Usage Guidelines
Enter the ATM-specific version of this command to specify an ATM PVC or SVC for voice or video
communications.
With SVCs and a dial map, dialed digits are reconciled with the remote ATM interface's voice NSAP
address,
Specifies the ATM interface number on the Cisco MC3810. The only valid
number is 0.
For SVC communications, a 40-digit hexadecimal number for the session
target network service access point (NSAP) address
The name of the session target ATM PVC
The ATM network virtual path identifier (VPI) and virtual channel
identifier (VCI) of this PVC
The ATM network virtual channel identifier (VCI) of this PVC
Modification
This command was introduced.
Support was added for VoFR, VoATM, and VoHDLC dial peers on the
Cisco MC3810.
The cid option was added for Frame Relay dial peers.
Support was added for voice and video ATM SVCs on the Cisco
MC3810.
Voice over ATM Switched Virtual Circuits on the Cisco MC3810 27
session target
Advertisement
