Advertisement
atm voice aesa
atm voice aesa
Enter the atm voice aesa ATM interface configuration command to set the unique ATM end-station
address (AESA) for an ATM voice interface using SVC mode. The no form of this command
removes any configured address for the interface.
atm voice aesa [default | esi-address]
no atm voice aesa
Syntax Description
default
esi-address
Defaults
The default keyword is the default.
Command Mode
Interface configuration
Command History
Release
12.0(5)XK and 12.0(7)T
Usage Guidelines
You cannot specify the ATM interface NSAP address in its entirety. The system creates either all of
it or part of it, depending upon how you use this command.
Examples
On a Cisco MC3810, the following example shows the ATM interface NSAP address set
automatically:
interface atm0
On a Cisco MC3810, the following example shows the ATM interface NSAP address set to a specific
ESI value:
interface atm0/1
24
Cisco IOS Release 12.0(7)T
atm video aesa default
atm video aesa 444444444444
The default keyword automatically creates an NSAP address for the
interface, based on a prefix from the ATM switch (26 hexadecimal
characters), the MAC address (12 hexadecimal characters) as the ESI (end
station identifier), and a selector byte (two hexadecimal characters).
Enter 12 hexadecimal characters as the end-station identifier (ESI). The
ATM switch provides the prefix (26 hexadecimal characters) and the voice
selector byte provides the remaining two hexadecimal characters.
Modification
This command was introduced for ATM interface configuration on the
Cisco MC3810.
Advertisement
