Advertisement
Step
Command
7
Router(config-dialpeer)# destination-pattern string [T]
8
Router(config-dialpeer)# session target ATM0 {svc nsap
address | pvc [vpi/vci | name]}
9
Router(config-dialpeer)# exit
10
Router(config)# dial-peer voice tag pots
11
Router(config-dialpeer)# destination-pattern string
12
Router(config-dialpeer)# port slot/port
Verifying Voice Ports and Voice Dial Peers
Step 1
To verify voice-port configuration, enter the privileged EXEC show voice port
command; you can either specify a voice port, or issue the command without arguments
to display information about all voice ports. The following text shows example output:
Router# show voice port 1/1
Voice-port1/1 Slot is 1, Port is 1
Type of VoicePort is E&M
Operation State is UP
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Verifying Voice Ports and Voice Dial Peers
Purpose
Configure the dial peer's destination pattern to allow the
system to reconcile dialed digits with the peer's NSAP
address. The string is a series of digits that specify the
E.164 or private dialing plan telephone number. Valid
entries are the digits 0 through 9 and the letters A through
D. The plus symbol (+) is not valid. You can enter the
following special characters:
• The star character (*) and the pound sign (#) that
appear on standard touch-tone dial pads can appear in
any dial string but not as leading characters (for
example, *650).
• The period (.) acts as a wildcard character.
• Use the comma (,) only in prefixes to insert a
one-second pause.
• Use the timer (T) character to configure variable-length
dial plans.
Configure the ATM session target for the dial peer.
Specify ATM 0 as the interface.
When you use SVCs, the system reconciles dialed digits
with the remote ATM interface's voice NSAP address.
If you are using PVCs for voice, you can specify a
Note
PVC defined on the ATM interface as a session target, by
using a name or a VPI/VCI combination. For additional
information, see Voice, Video, and Home Applications
Configuration Guide for Cisco IOS Release 12.0.
Exit dial-peer configuration mode for this particular dial
peer.
Define a local voice ATM dial peer.
The tag value identifies the dial peer and must be unique
on the Cisco MC3810. Do not duplicate a specific tag
number. Valid values are from 1 to 10000.
Configure the dial peer's destination pattern. See Step 7
for more information.
Specify the voice port where the voice equipment is
connected.
Voice over ATM Switched Virtual Circuits on the Cisco MC3810 13
Advertisement
