System Log Tab; Access Log Tab - Sony SNC-M1W User Manual

Factory default
Resets the camera to the factory settings.
Click Factory default, and "Set up data will be
initialized. Are you sure?" appears. When you click OK,
the network indicator and the power indicator on the
camera start to blink. After adjustments of the default
settings have finished, the camera reboots automatically.
Do not turn off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
pressing the reset switch on the camera. For details, see
the supplied Installation Manual.
Note
When the camera is reset to the factory settings, the IP
address you set is cleared. After rebooting of the camera,
input the IP address again (page 8).
Firmware upgrade
Use this when upgrading the camera software. Click
Browse and specify the file for upgrading, then click
OK. "Upgrade firmware? Are you sure?" is displayed.
Click OK and upgrading starts. After completion, the
camera starts again.
Notes
• Use only the upgrade file special to this camera. If you
do not, a problem may occur.
• Do not turn off the camera until the upgrading will be
completed.

System log Tab

System log
The data of the software activity of the camera are
recorded in this. It includes data that are useful when a
problem occurs.
Click Reload to reload to the latest data.

Access log Tab

Access log
The access record of the camera is displayed.
Click Reload to reload to the latest data.
Configuring the System — System setting menu
21