Honeywell HCCM474M User Manual page 25

MAIN MENU, CONTINUED
LINE LOCK PHASE ADJUSTMENT
1. Press SET to adjust line-lock phase when the cursor is at
SYNC MODE and the mode is set to L.L.
2. Press the left or right direction button to adjust line-lock
phase. Phase adjustment range is from 0 to 270°.
After setting, press SET to return to the MAIN MENU.
Note : In the line-lock setting, the camera's vertical synchronization can be driven by the 60Hz AC
(50Hz PAL) signal in the power lines.
• In the line-lock mode, synchronization may not be corrected for a few seconds after the power is turned
on ; this is not a malfunction.
• If horizontal lines rolling upward or down ward are observed on the screen, and reversed the polarity of
the power cable connected to the power input connector.
• When AC power line frequency is of 50Hz (60Hz PAL), the line-lock sync operation is not possible.
REV. B
➔
Phase 135 degree
Press SET to MAIN Menu.
25
LINE LOCK PHASE
HCMU000878
12/29/03