Station Info; Diagnostics - TP-Link TD-W8970N User Manual

window for listening to broadcast and multicast messages. When the Router has buffered
broadcast or multicast messages for associated clients, it sends the next DTIM with a DTIM
Interval value. Its clients hear the beacons and awaken to receive the broadcast and multicast
messages. The default value is 1.
Beacon Interval: Enter a value between 20-1000 milliseconds. The Beacon Interval value
indicates the frequency interval of the beacon. A beacon is a packet broadcast by the Router
to synchronize the wireless network. The default value is 100.
Transmit Power: This option will allow you to configure the wireless transmit power. High
transmit power will extend the wireless signal range of the device and make the signal
transmit more legible. Low transmit power with the smaller wireless signal range that will
decrease the probability of interrupt by other Wi-Fi device.
WMM (Wi-Fi Multimedia): This function can guarantee the packets with high-priority
messages being transmitted preferentially. It is strongly recommended.

4.5.6 Station info

Choose "Wireless" " Station Info", you will see the screen of Wireless--Authenticated
Stations setting shown as below.
This page shows authenticated wireless stations and their status.
MAC: Displays the connected wireless station's MAC address.
Associated: Displays whether the wireless station has associated with the access point.
Authorized: Displays the information of Authentication.
SSID: Displays the connected wireless station's SSID.
Interface: Displays the connected wireless station's Interface mode.

4.6 Diagnostics

Choose "Diagnostics", you will see the Diagnostics screen. This section describes the result of
the test for the ENET (Ethernet) Connection, Wireless Connection and ADSL Synchronization.
You can refer to the Help menu to get more information about the corresponding test.
TD-W8970N Wireless N ADSL2+ Modem Router User Guide
Figure 4-92
85