Specifications - Classe Audio CA-2100 Owner's Manual

28

Specifications

All specifi cations are accurate at the time of printing. Classé reserves the right to
adjust specifi cations without notice.
Power output
(both channels driven)
Frequency response
Phase
Signal-to-noise ratio
Channel separation
Noise floor (FFT)
Distortion (THD + noise)
Voltage gain
Sensitivity
Input Impedance
Rated power consumption (as per IEC60065 para. 2.3.10)
Idle power consumption
Mains voltage
Dimensions (not incl. controls or connectors)
Shipping weight
Net weight
For more information, see your Classé dealer, or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone +1 (514) 636-6384
FAX +1 (514) 636-1428
Internet: http://www.classeaudio.com
email: cservice@classeaudio.com
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command™ is a trademark of Equity International, Inc. All rights reserved.
AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.
100W/ch continuous rms @ 8Ω
200W/ch continuous rms @ 4Ω
10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
(ref. full ouput, 10Hz – 80kHz)
better than 110dB @ 20kHz
(unweighted, 1.0Vrms/1kHz input, 10Hz – 500kHz)
1.0Vrms for rated output @ 8Ω
(cannot be changed by dealer or user).
better than -10° @ 22kHz
better than -105dB
all peaks less than -95dBV
(10Hz – 80kHz)
0.003% @ 8Ω
29.1dB
100kΩ
260W
104W
specifi ed on rear panel
Width: 17.5" (445mm)
Height: 4.75" (121mm)
Depth: 16.5" (419mm)
55 lbs (25kg)
47 lbs (21kg)