Table of Contents
Advertisement
OPERATION
Continued
STORING,
TRANSPORTING,
OR SHIPPING
PREVENTATIVE
MAINTENANCE
SCHEDULE
6
5. Plug extension cord into standard 120 volt/60 hertz, three-hole, grounded
outlet. Heater will start when extension cord is plugged into outlet. If not,
push in flame-out control reset button (see Figure 3).
Flame-Out
Control
Reset Button
Figure 3 - Flame-Out Control Reset Button
To Stop Heater
1. Unplug extension cord from outlet.
To Restart Heater
1. Wait two minutes after stopping heater.
2. Repeat steps under To Start Heater, page 6.
Note:
If shipping, transport companies require fuel tanks to be empty.
1. Drain fuel tank.
Note:
Some models have drain plug on underside of fuel tank. If so, remove
drain plug to drain all fuel. If heater does not have drain plug, drain fuel
through fuel cap opening. Be sure all fuel is removed.
2. Replace drain plug if provided.
3. If any debris is noted in old fuel, add 1 or 2 quarts of clean kerosene to tank,
stir, and drain again. This will prevent excess debris from clogging filters
during future use.
4. Replace fuel cap or drain plug. Properly dispose of old and dirty fuel. Check
with local automotive service stations that recycle oil.
5. If storing, store heater in dry place. Make sure storage place is free of dust and
corrosive fumes.
IMPORTANT:
Do not store kerosene over summer months for use during next
heating season. Using old fuel could damage heater.
Never service heater while it is plugged in, operating, or
hot. Severe burns and electrical shock can occur.
Item
How Often
Fuel tank
Flush every 150-200 hours
of operation or as needed.
Air output and
Replace every 500 hours of
lint filters
operation or once a year.
Air intake
Wash and dry with soap and
filter
water every 500 hours of op-
eration or replace as needed.
!
WARNING
How To
See Storing, Transporting, or
Shipping, above.
See Air Output, Air Intake,
and Lint Filters, page 9.
See Air Output, Air Intake,
and Lint Filters, page 9.
102437
Advertisement
Table of Contents
