Table of Contents
Advertisement
OpERATING HEATER
Continued
WARNING: Always operate
manual control heaters at the
locked positions. Operation
between these positions may
create a possible health hazard
if used in a poorly ventilated
room. Read owner's manual for
complete instructions.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
TO TURN OFF GAS
TO APPLIANCE
To Shut Off Heater:
1. Turn control knob clockwise
OFF position.
2. Turn off all electric power to the appliance
if service is to be performed.
MANUAL LIGHTING
PROCEDURE
1. Remove front panel (see Figure 6, page 9).
2. Follow steps 1 through 7 under Lighting
Instructions, page 16.
3. With control knob pressed in, strike match.
Hold match to pilot until pilot lights.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow step 9,
under Lighting Instructions, page 16.
5. Replace front panel.
HAND-HELD REMOTE
OPERATION
The remote control transmits signals to
receiver. This remote control system was
developed to provide a safe, reliable and user
friendly remote control system for gas heat-
ing appliances. The system can be operated
manually from the remote control. The system
operates on one of 255 security codes on the
remote control and receiver. Security codes
can be set by the user.
IMPORTANT: The remote control will only
operate heater if pilot light is lit and control
knob is in the ON position.
16
Remote Control
The remote control has ON, OFF, THERMO-
STAT, and PROGRAM functions. This is part
of the system's design. If the LCD screen is
not working check the position of the remote
control's battery.
The remote control has two code switches
located on the back that will need to be set
when installation is complete, see Code Set-
ting page 19.
The remote control operates on 2 AAA 1.5V
size batteries (included) that powers the RF
signal and LCD screen. Before using the
remote control, batteries must be installed
into the battery compartments. See Installing
Batteries Into Remote, page 11.
to the
LCD Display
1. LOW - Battery power is low. Replace bat-
teries within two weeks.
2. PROGRAM - Indicates when unit is
functioning in one of the preset program
settings.
3. MODE - Indicates operation MODE of
system. ON indicates system is on either
manually or thermostatically. OFF indi-
cates entire system is turned off. THER-
MO indicates system will automatically
cycle on and off depending on program.
4. SET - Indicates desire set room tempera-
ture for THERMO operation.
5. FLAME - Indicates burner and valve in
operation.
6. CLOCK - Indicates current time in AM or PM.
7. ROOM - Indicates CURRENT room tem-
perature.
8. °F indicates degrees Fahrenheit (°C indi-
cates degrees Celsius).
www.desatech.com
OFF
ROOM
SET
PM
DOWN
UP
SET
TIME/PROGRAM
Figure 24 - Remote Control
LCD
Display
Mode
Buttons
Front
Cover
118621-01B
Advertisement
Table of Contents
