Specifications - Desa LSL3124N Owner's Operation And Installation Manual

CLEANING AND
MAINTENANCE
Continued
Clean the pilot assembly also. A yellow tip on the pilot flame
indicates dust and dirt in the pilot assembly. There is a small pilot
air inlet hole about two inches from where the pilot flame comes out
of the pilot assembly (see Figure 30). With the unit off, lightly blow
air through the air inlet hole. You may blow through a drinking straw
if compressed air is not available.
Burner Tube
Primary Air Inlet Holes
(Shape of Holes May
Vary by Model)
Figure 29 - Injector Holder On Outlet Burner Tube
Burner Tube
Pilot Assembly
Pilot Air
Inlet Hole
Figure 30 - Pilot Inlet Air Hole
LOGS
• If you remove logs for cleaning, refer to Installing Logs, pages
13 and 14, to properly replace logs.
• Replace log(s) if broken or chipped (dime-sized or larger).
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111347-01B
Cleaning Burner Injector Holder and Pilot Air Inlet Hole (Cont.)
Injector Holder (May
Be Brass or Aluminum
Depending on Model)
Ports/Slots
CLEANING AND MAINTENANCE

SPECIFICATIONS

Btu (Variable)
Type Gas
Ignition
Manifold Pressure
Inlet Gas Pressure (in. of water)
Maximum
Minimum*
Shipping Weight
* For purpose of input adjustment
Btu (Variable)
Type Gas
Ignition
Manifold Pressure
Inlet Gas Pressure (in. of water)
Maximum
Minimum*
Shipping Weight
* For purpose of input adjustment
19
19
Logs
SPECIFICATIONS
Echo Valley Oak Log
Variable Manually-Controlled
16,000/31,500
Propane/LP - Natural
Piezo
8.0" W.C. - 3.5" W.C.
14" - 10.5"
11" - 5"
38 lbs.
Meadowbrook Oak Log
Thermostatically-Controlled
26,000/39,000
Propane/LP - Natural
Piezo
8.0" W.C. - 3.5" W.C.
14" - 10.5"
11" - 5"
28 lbs.