Encore ENVCWI-PTG1 - ADVANCED INSTALLATION GUIDE V1.1 Installation Manual page 34

Network >> IP Filter
The IP Filter setting allows the administrator of the camera to limit
the users within a certain range of IP addresses to access the
camera.
Start/End IP Address
Assign a range of IP addresses that are not allowed to access
the camera by entering the Start IP address and End IP address.
When you finish the setting, click Add to save the range setting.
You can repeat the action to assign multiple ranges for the
camera.
For example, when you enter 192.168.0.50 in Start IP Address
and 192.168.0.80 in End IP Address, the user whose IP address
located within 192.168.0.50 ~ 192.168.0.80 will not be allowed to
access the camera.
- 33 -