Active Crossover - DLS MRA22 - MANUAL 2 Manual

Speaker wiring MRA 41
3. One 2-way speaker system to MRA41 using
active crossover between tweeter and
midrange / bass
Midrange
Filter settings A/B Channels
HPF
50Hz 220Hz
15Hz 500Hz
Off On
We want a crossover point of 4 kHz between tweeter
and midrange. If you for some reason want to limit
the low bass reproduction switch on the HPF-filter.
The typical setting is then around 60 – 80 Hz. Switch
the LPF-filter switch to ON and the Multiply switch
to x10 position. Now you can adjust the filter setting
from 500 Hz to 5 kHz. Adjust the setting to 4 kHz.
Filter settings C/D Channels
HPF Multiply
50/500Hz 220/2(k)Hz
Off On x1 x10
15/150Hz 500/5(k)Hz
Channel C/D are used for tweeters and must be set
to play from 4 kHz and up. The HPF-filter switch
must be ON and the multiply swich in x 10 position.
Now you can adjust the filter setting from 150Hz to
5 kHz. Adjust the setting to 4 kHz.
10
C D
Tweeters
LPF
Multiply
80/800Hz 200/2(k)Hz
x1 x10
Off On
50/500Hz 500/5(k)Hz
MRA41