Install Ductwork - Electrolux EI30DD10KS Installation Instructions Manual

Install Ductwork

Re-attach Transition Duct
The Transition Base must be installed with the flange
at the top. Position the duct Transition Cover on the
Transition Base for the discharge direction selected.
The top edge of the duct Transition Cover must be
under the tabs of the Transition Base.
Down Discharge – Attach the transition with 4 screws
as shown.
Transition
Base
Discharge Down (as supplied)
Left or Right Discharge – Remove the Phillips head
screw from the chassis. Attach the transition with 5
screws as shown.
Remove Phillips
Head Screw
from Left Hole
and Reattach as
Shown
Discharge Left
Duct Transition
Cover
(4) Phillips
Head Screws
Connect the ductwork
- Use galvanized or aluminum duct in 8" or 10" round
or 3 ¼" x 14" size, or a combination of both. PVC
duct should be used if installing under a poured
concrete slab. Use the shortest and straightest duct
run possible.
(4) Phillips
Head Screws
Local building codes must be followed in specifying
approved type and specifications of ALL duct used.
Always use an appropriate roof or wall cap with damper.
All ductworks must be as installed as per local codes.
Duct Tape Over Seam and Screw
Connect Downdraft to Power
- Plug the downdraft's power cord into the outlet.
- Make sure the power cord is routed beneath the
appliance and away from heat generated by the
cooktop.
Install Cooktop
(4) Phillips
Head
- Align the cooktop with the downdraft and fasten
Screws
cooktop in place.
Accurate alignment of cooktop and downdraft is
necessary to ensure that there is no interference
when air vent is raised and lowered. There should
be a gap of 1/8" between the back of the cooktop
and the front of the downdraft cover.
Installation
Remove Phillips
Head Screw from
Right Hole and Attach
as Shown
Discharge Right
NOTE
IMPORTANT
Screw
NOTE
13
Air Flow