Solutions to Common Problems
Problem
Solution
Telescoping Vent
- Check for and remove obstructions. The telescoping vent is designed to tilt and
does not fully
stop with obstructions. The raise/lower push button will reverse direction of travel
raise
and reset the telescoping vent travel. Allow the telescoping vent to fully raise or
lower after encountering an obstruction.
- If the telescoping vent does not response to the raise/lower push button, it can be
straightened or helped along by hand and the switch should be tried again.
- DO NOT attempt to lubricate the telescoping vent. It is factory lubricated for life.
Blower does not
- Make sure telescoping vent is in the upper most position.
turn on
- Make sure the blower slide adjustment is not in the off position.
- If used for an extended period of time, allow the blower to cool. The blower is
thermally protected and will shut off until cooled sufficiently. It will resume normal
operation when cool.
Questions or for service call:
Before you call
1-877-4ELECTROLUX
(1-877-435-3287)
17