Arcam SOLO MUSIC Handbook page 12

DAB Setup
This menu item is shown only when the selected source is DAB.
There are two options under this menu item – 'Scan' and 'Erase settings'. Selecting 'Scan' causes Solo
to search for new DAB stations. If any are found, then they will be added automatically to the list of
available stations.
Scanning for new stations does not erase old stations that are no longer transmitted – over time, or if
you change location, this may lead to you having a number of stations in your list that cannot actually be
received. In this case, select 'Erase settings', then perform a new scan; when the scan is complete, only
stations that are available currently in your area will be shown.
Set Preset
This menu item is shown only when the selected source is DAB, FM or AM.
See the section 'Programming station presets' on page 7 for more information.
Adjusting Zone 2 volume
Press and hold on the front panel until 'Z2 Vol' is displayed, then use the volume control to
MENU
decrease/increase the Zone 2 volume. Press
Setting the clock
Stand-by state
Setting alarms
again to exit.
MENU
Previous item Next item
Previous item Next item
Alarms go off at the scheduled
time for highlighted days. In this
example, alarms are set to go off
on weekdays only.
Setting the clock and alarm
When Solo is in stand-by, press to set the clock or alarms.
MENU
Use the left and right buttons on the remote control to select the item to change, then use the up and
down buttons to change the value. For example, after pressing
menu, pressing up and down will change between setting the clock and setting one of the alarms.
Solo allows up to four different alarms to be set.
Stopping or pausing an alarm
To stop an alarm ringing, press the power button on the front-panel or remote control. Alternatively, press
to enter 'snooze' mode; the alarm will re-sound after a 10-minute delay. To cancel snooze-mode, press
OK
the power button.
Earlier
Set the time
(hours)
Later
12HR
Set 12/24
hour clock
24HR
Select an alarm
or set the clock
Off
Set alarm
on or off
On
Earlier
Set hours
for alarm
Later
Earlier
Set minutes
for alarm
Later
E12
to enter the clock/alarm setting
MENU
Confirm
settings
Previous
Set the
day
Next
Earlier
Set the time
OK
(minutes)
Later
Exit to
time-of-day
display
Stand-by state
Exit to
time-of-day
display
AM
Set AM
or PM
PM
Off
Set alarm days
on or off
On
Select a
signal source