Playing From The Rwand Ipod Transmitter - Arcam RCUBE Manual

Playing from the rWand Optional iPod Transmitter
NOTE: You need to associate each cube with a wireless transmitter before that
cube can receive the transmitter's audio.
1
Install the rWand iPod transmitter into your iPod, iPhone or iPad.
Plug the rWand transmitter into the docking connector at the bottom
of your Apple player. You can check to see if the rWand is broadcasting
by looking at its LED, which will flash briefly every five seconds when
transmitting.
2
Power up
Plug the power supply into the AC mains wall supply and the DC power
input jack on the rear panel of the rCube. Switch on the rCube by pressing
power switch on the rear panel, and press the top panel standby button.
The blue power LED should light.
3
Select the rWand as wireless source
To select the rWand iPod transmitter, press the 'Wireless' button
on the remote control or on the top panel. If a source is available the light
will turn green and the source will begin to play. Note: if a second wireless
source is also transmitting you may have to press the 'Wireless' button
twice to select the correct transmitter.
4
Play tunes on the iPod/iPhone/iPad
NOTE: Some Apple devices require you to select the iPod music player
application.
5
Adjust volume
Use the + and - volume buttons on the remote or on the top panel to adjust
the volume to desired level. The rCube volume can also be adjusted using
the iPod's volume control.

E-21
MEN U
, .
;4
O I
2

