Suzuki SIDEKICK 2-DOOR HARDTOP - 1995 Owner's Manual page 132

Front Clearance/Turn Signal Light,
Tail/Stop/Back-up Combination Light,
Side Marker Light, License Plate Light
Two types (small oval and round) of bulb
are used for these lights. To remove and
install a small oval bulb, simply pull out
or push in the bulb.
To remove a round bulb from a bulb
holder, push in the bulb and turn it
counterclockwise. To install a new bulb,
push it in and turn it clockwise.
To remove a bulb holder from a light
housing, turn the holder counterclock-
wise and pull it out. To install the holder,
push the holder in and turn it clockwise.
You can access the individual bulb holders
as described below:
133
Front clearance/turn signal light
Open the engine hood. The bulb holder
is located at the outboard side of the
headlight.
INSPECTION AND MAINTENANCE
Tail/stop/back-up combination light
Undo the two screws at the bottom end
of the light housing and remove the
housing.
9-28