Air Conditioning System (If Equipped) - Suzuki SIDEKICK 2-DOOR HARDTOP - 1995 Owner's Manual

Head Cooled/Feet Warmed Heating
Move the function lever to "BI-LEVEL",
the air intake lever to "FRESH AIR", the
temperature control lever to the desired
temperature position, and the fan lever
to the desired fan speed position. Unless
the temperature control lever is in the fully
"COLD" position or fully "HOT" position,
the air that comes out of the center and
side outlets will be cooler than the air
that comes out of the floor outlets.
Defrosting/Feet Warmed Heating
Move the function lever to "DEFROST &
HEATER", the air intake lever to "FRESH
AIR", the temperature control lever to
the desired temperature position, and
the fan lever to "HIGH". When the wind-
shield has become clear, move the fan
lever to the desired fan speed position.
Defrosting
Move the function lever to "DEFROST",
the air intake lever to "FRESH AIR", the
temperature control lever to the desired
temperature position (Higher temperature
provides more efficient defrosting.), and
the fan lever to "HIGH". When the wind-
shield has become clear, move the fan
lever to the desired fan speed position.
43
60A23-04HO
AIR CONDITIONING SYSTEM
(If Equipped)
VENTILATION
If your vehicle is equipped with air con-
d i t i o n i n g , it w i l l have an A/C button
located to the right of the air intake lever.
The air conditioning system can be used
to provide cooling and dehumidifying, as
described below. To turn on the air con-
ditioning system, push in the A/C button
and move the fan lever to a position other
than "OFF". An indicator light will come
on when the air conditioning system is
o n . To t u r n off the air c o n d i t i o n i n g
system, push the A/C button again.
During operation of the air conditioner,
you may notice slight changes in engine
speed. These changes are normal, the
system is designed so that the com-
pressor turns on or off to maintain the
desired temperature. Less operation of
the compressor results in better fuel
economy.
INSTRUMENT PANEL
HEATER & DEFROST
DEFROST
FRESH
RECIRCULATED
AIR
System Operating Instructions
Normal Cooling (Using outside air)
Push in the A/C button, move the func-
tion lever to "VENTILATION", the air in-
take lever to "FRESH AIR", the tempe-
rature control lever to the desired tem-
perature position, and the fan lever to the
desired fan speed position. Moving the
fan lever to a higher fan speed position
increases cooling efficiency.
Quick Cooling (Using recirculated air)
The lever settings are the same as for nor-
mal cooling except you move the air in-
take lever to "RECIRCULATED AIR". If you
use this cooling method for an extended
period of time, the air in the vehicle can
become contaminated. Therefore, you
should occasionally move the air intake
lever to "FRESH AIR".
4-12