Pnp/Pci Configuration Setup - Intel 630 - Pentium 4 630 3.0GHz 800MHz 2MB Socket 775 CPU User Manual

PCIPME Power Up Control
This will enable the system to wake up by PCI device Power Management function.
The settings are: Enabled and Disabled.
KB Power ON Password
This item can setting Power On Password, if you Enabled keyboard Power On function then
you can Power On system by key-in the password which you setting.
Power Up by Alarm
This function is for setting date and time for your computer to boot up. During Disabled,
you cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to
the operating system, before this function will work.

3-9 PnP/PCI Configuration Setup

This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed
the CPU itself uses when communicating with its own special components. This section
covers some very technical items and it is strongly recommended that only experienced
users should make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2000 Award Software
Reset Configuration Data
Resources Controlled By
> IRQ Resources
PCI/VGA Palette Snoop
Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit
¡ ü ¡ ý ¡ ú ¡ û
F5:Previous Values
PnP/PCI Configurations
Disabled
Manual
Press Enter
Disabled
F6:Optimized Defaults F7:Standard Defaults
38
Item Help
Menu Level >
Default is Disabled.
Select Enabled to
Reset Extended System
Configuration Data
(ESCD) when you exit
Setup if you have
Installed a new add-on
and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot
F1:General Help