Checking The Xm Signal Strength And Radio; Searching Categories; Ipod ® Playback; Basic Operation - Denon AVR-1908 Owner's Manual

Checking the XM Signal Strength and
Radio ID
1
<SOURCE SELECT>
Either turn or press
select "XM".
2
STATUS
Press until "SIGNAL" appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
GOOD Signal strength is good
Signal strength is marginal
MARGINAL
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
STATUS
Press until the station you want to check
(example: "XM001") is displayed.
5
TUNING
Press and select channel 0 (XM000).
The radio ID is shown on the display.
Radio ID
X M 0 0 0 R A D I O I D
The strength of both the XM satellite and terrestrial signals can be
checked at menu "Input Setup" – "Antenna Aiming" (vpage 34).

Searching Categories

1
Press o p .
Channel category
C A T : R o c k
2
Use o p to select the category, then use
the desired station.
iPod ® Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
[SAT TU] The operation can also be performed using the buttons on the main
to
unit or remote control unit while watching the menus.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.

Basic Operation

1
Make the necessary preparations.
q S et the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod's operating instructions.)
w Assign the Control Dock for iPod's input.
MENU : "Input Setup" – "Assign" – "iPod dock"
(vpage 33)
2
<SOURCE SELECT>
Either turn
select the input source assigned in step 1-w above.
b
If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
[MODE SELECTOR 1]
Set
SELECTOR 2]
to "iPod/NETWORK".
(vpage 48 "Remote Control Unit Operations")
ui to select
• With the default settings, the iPod can be used connected to the VCR
• Use the RESTORER mode to expand the low and high frequency
• Press <ON/STANDBY> and set the AVR-1908's power to the standby
• Depending on the type of iPod and the software version, some
• DENON will accept no responsibility whatsoever for any loss of iPod
[iPod]
or press to
OK to disconnect.
(iPod screen)
[MODE
to "AUDIO" and
(iPod) connector.
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" .
mode before disconnecting the iPod. Also switch the input source
to one to which the menu "iPod dock" is not assigned before
disconnecting the iPod.
NOTE
functions may not operate.
data.
ENGLISH