Error Messages; Parameter Check - Denon AVR-1908 Owner's Manual

ENGLISH

Error Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over
again.
Error messages (examples)
• Included setup microphone is not connected.
Auto Setup
Audyssey MultEQ
Caution!
• Not all speakers could be detected.
Microphone:None
or
Speaker :None
Retry
Cancel
• Too much noise in the room for accurate
Auto Setup
Audyssey MultEQ
Caution!
Ambient noise is
• Speaker or subwoofer sound is too low for
too high or
Level is too low.
Retry
Cancel
• Displayed speaker could not be detected.
Auto Setup
Audyssey MultEQ
Caution!
Front
R :None
Retry
Cancel
• Displayed
Auto Setup
Audyssey MultEQ
Caution!
Front
L :Phase
Retry
Cancel
Skip
Select "Retry" to measure again.
NOTE
Be sure to turn the power off before checking the speaker connections.

Cause
measurements to be made.
accurate measurements to be made.
· The front R speaker were not properly
detected.
· Only one channel of the surround speakers
was detected.
· Sound was output from the R channel
when only one surround back speaker was
connected.
· The surround back, but the surround speaker
was not detected.
speaker connected with the
polarities reversed.
Measures
• Connect the included setup microphone to the SETUP
MIC jack on the main unit.
• Check the speaker connections.
• Either turn off any device generating noise or move it
away.
• Try again when the surroundings are quieter.
• Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed speaker.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may be
displayed even if the speaker is properly connected. If
you are sure that the wiring is correct, select "Skip" .
s Option
Make various other settings.
Room EQ
Select room EQ setting method.
[Selectable items]
All
: Apply settings to all surround modes.
Assign
: Make settings for each surround mode separately.
Direct Mode Setup
Select room EQ use for DIRECT or PURE DIRECT mode.
[Selectable items]
ON
: Use room EQ.
OFF
: Do not use room EQ.
d Parameter Check
Check auto setup measurement results.
This is displayed after the auto setup procedure is completed.
[Selectable items]
Distance Check
Speaker Config. Check
Channel Level Check
Crossover Freq. Check
EQ Check
The auto setup results can be set again when "Restore" is selected.