Setting The Volume Control; Setting The 2Ch Direct/Stereo Custom - Denon AVR-1707 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 1

Setting the Volume Control

This sets the volume level of output.
1
D D H H
Press to select the item, then press
Volume Limit:
Set the volume's upper limit.
• 0 dB, –10 dB, –20 dB:
The volume cannot be increased above the selected levels.
• OFF:
If you do not want to set a volume limit, select "OFF".
In this case, the volume can be set to the AVR-1707's maximum
volume (output) level of +18 dB, which is extremely loud.
Power On Volume Level:
• LAST:
The volume set when the AVR-1707 was last used is stored in the
memory and set when the power is turned on.
• – – – (Mute):
The volume is always muted when the power is turned on.
• –80 dB ~ +18 dB:
Set the volume level when the power is turned on.
You can adjust the volume level within the range of –80 to +18 dB.
Muting Level:
Set the level of volume attenuation in the mute mode.
• FULL:
The volume is fully muted.
• –40 dB, –20 dB:
The volume is lowered 40 dB or 20 dB from the current level.
2
ENTER H H
Press or to enter the setting and switch to
the 2ch Direct/Stereo Custom setting.
1
2 L i m i t - 1 0 d B
3 P . O n L A S T
4 M u t e F U L L
2
5 2 c h C s t m

Setting the 2ch Direct/Stereo Custom

Make the 2-channel direct mode and stereo mode speaker settings.
1
F F G G F F
to set. Press to select "ON", then press
2 D D H H
Press
Large:
Select this when using large speakers with ample low frequency
reproduction capabilities.
Small:
Select this when using small speakers without ample low
frequency reproduction capabilities.
Yes, No:
Select "Yes" when a subwoofer is connected, "No" when no
subwoofer is connected.
LFE (Normal):
For any channel(s) that are set to "Large", low frequencies in that
channel's corresponding source are directed to that loudspeaker
only. The low frequencies played from the subwoofer are only the
LFE signals and the low frequencies of channels set to "Small".
LFE+Main:
Low frequencies from speaker channels that have been set to
"Large" are reproduced from those speakers as well as from the
subwoofer(s).
Crossover Frequency (40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz):
Set as desired according to your speakers' bass playback ability.
3
ENTER
Press
the Auto Surround Mode setting.
O F F
H H
.
F F G G
to select the item, then press to set.
H H
or to enter the setting and switch to
42
ENGLISH
Advanced Setup – Part 1
1
5 2 c h C s t m O N
2
6 2 c h F L a r g e
7 2 c h S W Y e s
8 2 c h L F E N o r m
9 2 c h F L 3 . 6 m
1 0 2 c h F R 3 . 6 m
1 1 2 c h F r e q 8 0
3
1 2 A u t o S u r r . O N