Other Functions; Recording The Program Source (Recording The Source Currently Being Monitored); Last Function Memory; Initialization Of The Microprocessor - Denon AVR-1306 Operating Instructions Manual

ENGLISH
Advanced Operation
INPUT SELECTOR
POWER SPEAKER

Other functions

Recording the program source (recording the
source currently being monitored)
1
Select the input source to be played.
2
Select the input mode and play (surround) mode.
3
Start recording on the tape or video deck.
For instructions, refer to the component's operating instructions.
• The AUDIO IN's signal selected with the INPUT SELECTOR knob
are output to the CDR/TAPE and VCR AUDIO OUT terminals.
2 Simultaneous recording
The signals of the source selected with the INPUT SELECTOR knob
are output simultaneously to the CDR/TAPE and VCR REC OUT
terminals. If a total of two tape and/or video decks are connected
and set to the recording mode, the same source can be recorded
simultaneously on every decks.

Last function memory

• This unit is equipped with a last function memory which stores
the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function
provides approximately one week of memory storage when the
main unit's POWER switch is off and the power supply cord
disconnected.
35
ENGLISH

Initialization of the microprocessor

If the indication on the display is not normal or if the operation of
the unit is not correct, then the microprocessor should be reset
by the following procedure.
1
Switch off the unit using the main unit's
switch.
2
SPEAKER A B
Keep both and
and turn on the unit by pressing the main unit's
POWER
switch.
3
Check that the entire display is flashing at 1-
second intervals and release the buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
Advanced Operation
POWER
buttons depressed