Deja Vu - Lexicon VORTEX User Manual

Mod Fx Lvl
ECHO 1 ECHO 2
Fbk 1
Fbk 2
Mod Fx Lvl
* ENVELOPE Decreases ECHO FX LVL
ECHO FX LVL Delayed output into stereo glide
MOD FX LVL Undelayed input to stereo glide
FEEDBACK 1 Input/feedback mix (1=no feedback; 64=infinite repeat)
FEEDBACK 2 Feedback/cross-feed mix
RATE 1 Stereo glide rate
DEPTH 1 Stereo glide depth
RESONANCE 1 Stereo resonance
RATE 2 Autopan rate
DEPTH 2 Autopan width (min=center, max=L to R)
RESONANCE 2 Stereo glide cross-resonance gain
Echo
Fx Lvl*
STEREO
PAN
GLIDE
Rate 2
Depth 2
Rate 1
Depth 1
Res 1
Res 2
Deja Vu A is configured with a cascade looper with envelope
control of the looper's output level. The output of the looper is
fed into a panner which sprays the effect into a stereo glide.
The stereo glide is also fed directly by the inputs.
ENVELOPE decreases ECHO FX LVL, pulling the echoes down
out of the way of loud signals, and bringing them back up whenever
softer signals are received.
FEEDBACK 2 controls the mix of ECHO 1 feedback and ECHO 2
feedback. When this value is 1, this mix is all ECHO 1 feedback. At
64, the mix is all ECHO 2 feedback (producing the longest echoes.)
Between these extremes, ECHO 1 is fed by a mixture of the two
feedbacks. These intermediate settings produce echo rhythms that
change over time.
FEEDBACK 1 controls the mix of input signal and feedback mix
fed into ECHO 1. When FEEDBACK 1=1, there is no feedback. At 64,
only feedback is sent into the echoes. This creates an infinite loop.
Setting DEPTH 2 to 1, in effect, turns off the panner.
In the Preset, the panner and the stereo glide are turned off,
leaving just a simple echo ducking effect. Turn up DEPTH 1 and
DEPTH 2 to add modulation and panning.
42
A

9 DEJA VU