Table of Contents
Advertisement
DANGEROUS PROCEDURE WARNINGS
Warnings such as the examples below precede potentially dangerous
procedures throughout this document. Instructions contained in the
warnings must be followed.
Dangerous voltages capable of causing death are
WARNING
present in this instrument. Use extreme caution
when handling, testing, or adjusting.
These service instructions are intended for use by
WARNING
qualified personnel only. Do not perform any
servicing other than that contained in these
instructions unless qualified to do so. Refer to the
Safety Summary on page 2 prior to performing
any service.
ELECTROSTATIC DISCHARGE
(ESD) PRECAUTIONS
CAUTION
The following practices minimize possible damage to ROMs resulting from
electrostatic discharge or improper insertion.
•
Keep parts in original containers until ready for use.
•
Avoid having plastic, vinyl, or Styrofoam in the work area.
•
Wear an anti-static wrist strap.
•
Discharge personal static before handling devices.
•
Remove and insert boards with care.
•
When removing boards, handle only by non-conductive surfaces and
never touch open-edge connectors except at a static-free workstation.*
•
Minimize handling of ROMs.
•
Handle each ROM by its body.
•
Do not slide ROMs or boards over any surface.
•
Insert ROMs with the proper orientation, and watch for bent pins on ROMs.
•
Use anti-static containers for handling and transport.
*
To make a plastic-laminated workbench anti-static, wash with a solution of
Lux liquid detergent, and allow to dry without rinsing.
Advertisement
Table of Contents
Need help?
Do you have a question about the MPX G2 V1.1 - INSTALLATION AND RELEASE NOTES and is the answer not in the manual?
Questions and answers