Lexicon MPX G2 V1.1 - INSTALLATION AND RELEASE NOTES Installation Instructions Manual page 2

SAFETY SUMMARY
The following general safety precautions must be observed during all phases of operation, service, and repair of this unit. Failure to comply with
these precautions or with specific warnings elsewhere in these instructions violates safety standards of design manufacture and
intended use of this unit. Lexicon, Inc. assumes no liability for failure to comply with these requirements.
GROUND THE INSTRUMENT
To minimize shock hazard, the unit chassis and cabinet must be
connected to an electrical ground. The unit is equipped with a three-
conductor AC power cable. The power cable must be either plugged
into an approved three-contact electrical outlet or used with a three-
contact to two-contact adapter with the grounding wire (green) firmly
connected to an electrical ground (safety ground) at the power outlet.
The power jack and mating plug of the power cable meet International
Electrotechnical Commission (IEC) safety standards.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the unit in the presence of flammable gasses or
fumes. Operation of any electrical instrument in such an environment
constitutes a definite safety hazard.
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove unit covers. Component
replacement and internal adjustments must be made by qualified
maintenance personnel. Do not replace components with power cable
connected. Under certain conditions, dangerous voltages may exist
even with the power cable removed. To avoid injuries, always
disconnect power and discharge circuits before touching them.
DO NOT SERVICE OR ADJUST ALONE
Do not attempt internal service or adjustment unless another person
capable of rendering first aid resuscitation is present.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Because of the danger of introducing additional hazards, do not install
substitute parts or perform any unauthorized modification to the unit.