Advanced Editor Mode - Lexicon MPX G2 V1.1 - INSTALLATION AND RELEASE NOTES Installation Instructions Manual

MPX G2
Option Description
Samples* Displays the setting as a number based
on a 44.1kHz sample rate (22.7uS per
sample). Resonance effects can be
created by adjusting the Time parameter
when feedback parameters are set high.
* Lag time in the A/D/A converters sets absolute minimum time in the box
to about one millisecond. Sample delays should be added to this time
to calculate the accurate delay time.

ADVANCED EDITOR MODE

Advanced Editor Mode can be used to change User Bank
program names.
To enable Advanced Editor Mode:
1. Load the desired program. (See page 2-2 in the MPX
G2 User Guide for instructions to load programs.)
2. Press the front panel Store button. The Store button
LED will flash to indicate that Store Mode has been
enabled.
Software Version 1.1 Installation Instructions & Release Notes
(continued)
3. Press the front panel Options button to enable
Advanced Editor Mode. Press the Options button
again to disable Advanced Editor Mode.
The Options button LED will flash to indicate that
Advanced Editor Mode is enabled. The Effect buttons will
also flash, indicating that these buttons serve as controls
in this mode. See the Advanced Editor Mode Controls
section that begins on the next page for descriptions of
each button function.
The front panel display will appear as shown in the figure
below. The name of the selected program will appear on
the top line of the display. A cursor will flash beneath the
first character in the program name. A horizontal list of
available letters, numbers, and symbols will appear on
the bottom line of the front panel display.
. . . Advanced Editor Mode continues on page 16
15