Sc101 Command Line Interface (Cli) For Advanced Users; Using Cli Commands - NETGEAR SC101 - Storage Central NAS Server Revised Troubleshooting Manual

SC101 Command Line Interface (CLI) for Advanced
Users
Some SC101 commands and information are available only through the CLI. (For more about
CLIs, see What is a CLI?.) Compared to the Wizard, the CLI is a very fast way to check the basic
status of the SC101.

Using CLI Commands

1.
Type Start > Run > command. (In Windows 2000 or Windows XP, Start > Run > cmd).
A black and white window pops up, with a blinking cursor after the prompt (the prompt
ends with a greater than sign ">").
2.
Type cd c:\Program Files\NETGEAR\SC101*
This changes the directory. It also changes the prompt, so that you can see what
directory you are in.
3.
Type ut listall, then Enter.
The computer responds with a screen of data similar to:
This is an overview of all the disks and partitions in the SC101. The information is divided
above and below the double line of "====", one group for each of the two physical hard
disks placed in this example SC101.
# PARTITIONS Number of partitions created on each hard drive. In this
example, there are four partitions, each with a line of
characters. If you just created one partition, there would be
one line
23