Command: Ut_Full Getpart; Fixing Corrupted Characters - NETGEAR SC101 - Storage Central NAS Server Revised Troubleshooting Manual

Storage central

Hide thumbs Also See for SC101 - Storage Central NAS Server:

Table of Contents

If a CLI is inside of a Windows pop-up, you can close it by typing exit then RETURN. It doesn't do

any harm to leave it open, if you might want it later.

Command: ut_full getpart

You can use this command to see if there are corrupted characters.

In the following screen shot, see the last row. It is a response to an ut_full getpart command, and

shows the numbers that can become corrupted. Here, in the middle of the row, are the correct

numbers: 02 00 02 or 01 00 01.

If a mirrored drive is broken, in place of 02 00 02, the numbers are 02 00 01 (shown).

If a non-mirrored drive is broken, the numbers are 01 00 01 (shown).

This involves using a special SC101 command called ut_full.

NETGEAR recommends using this utility. Do not use it to change attributes of partitions that are

working correctly. This might destroy data!

You will need to use the ut_full getpart, ut_full listall, and ut_full newattri commands.

1. Download the file below to the SC101 directory (If you installed to the default location,

C:\Program Files\NETGEAR\SC101 Manager Utility\)

2. Unzip the file. The ut_full.exe file appears in the directory.

NOTE: This is the only situation

37.3 KB

Table of Contents