NETGEAR RN12P0610 - ReadyNAS 3200 Hardware Manual page 32

ReadyNAS 3200 Hardware Manual
2. Pull the disk tray release pull switch. The disk tray handle pops out.
Disk tray
handle
Figure 2-10
3. Pull out the disk tray, and replace the failed disk.
Figure 2-11
Make sure that the hard disk connectors face the interior of the disk bay when you reassemble
the disk.
4. Slide the disk tray back into the ReadyNAS and secure the handle.
The volume automatically synchronizes with the new disk in the background. The process
takes several hours depending on the disk size. During this process, the ReadyNAS can be
used as normal, although access will be slower until the volume finishes synchronizing. You
will be notified by e-mail when the process is complete.
2-14
v1.1, July 2009
Failed disk LED
Disk tray release
pull switch
Diagnostics and Maintenance