NETGEAR RN12P0610 - ReadyNAS 3200 Hardware Manual page 24

ReadyNAS 3200 Hardware Manual
1. While using a paper clip or push pin to gently press in the reset switch, power on the unit. Wait
for the two red boot menu status lights on the front to display, then release the reset switch.
Control Panel Boot Menu Options
Boot Menu Sequence
LED Legend:
Boot Menu Enabled
1. Normal Boot
2. Factory Default
3. OS Reinstall
4. Tech Support
Red
Red
5. Skip Volume Check
Power
Fan
6. Memory Test
LED
LED
7. Factory Test
2. Push the Reset button on the front panel three times to select the OS Reinstall option.
Warning: If you mistakenly select the Factory default option, all data on the unit
The system will do the following:
a. Display the OS Reinstall blink pattern.
b. Hold the display of the final LEDs (off on), and wait for you to confirm the selection.
3. Press the and hold the reset button for 3 seconds to confirm the menu selection and proceed
with that option.
The system will do the following:
a. Blink both LEDs twice to confirm the selection.
b. Proceed with reinstalling the firmware.
c. Reboot when the firmware reinstall completes.
The data will be in tact. The user name, password, and system configuration settings will be
the factory default values.
2-6
Off Off



will be deleted. If you are unsure, let the system boot normally, before
attempting this procedure again.
v1.1, July 2009
Red Power LED and Red Fan LED Blink Patterns
 
On On

  

Off On
Diagnostics and Maintenance